The AN410 pressure controller module is intended for pressure closed-loop-controls in conjunction with a pressure control valve
When the controller enable is switched off, the unit operates as an open loop controller in which the system pressure is adjusted in the usual manner by the valve current in conjunction with the control characteristic
When the controller is enabled, the well-known disadvantages of open loop control are compensated and the pressure is controlled free of hysteresis, irrespective of the temperature and linear to the setpoint
The actual pressure value is monitored for wire break and is available as a 0...10V signal on terminal 12 for measurement purposes
Adaptation to the control system is possible using the P and I potentiometers
Snap-on housing enables the AN410 module to be mounted on normal carrier rails in control cabinets.
Electrical connections are done by a terminal strip and 3 flat connectors

Type		Pressure controller
Use		Pressure closed-loop-control in conjunction with a pressure control valve
Supply voltage		24V DC (22...32 V DC)
Temperature range		0...+50°C
Output stage		Duplex output stage with high dynamic response and rapid deexcitation (approx. 4...6 ms)
PWM frequency		Approx. 5kHz
Input (various input modules are available)		Setpoint: - 0...10V (differential input) - 4...20mA (monitored diff. input) - 0...20mA (differential input) Actual value: - 4...20mA (monitored diff. input)
Measuring sockets		Current: valve current: 1V/A (10%) Command: setpoint signal (0...10V) M1: controller output
For mer informasjon		Klikk her --- Datablad