Signal conditioner for strain gauge which can accept very low bridge resistance values ( 80 ohm)
Gain and zero can be easily regulated by dip-switch and potentiometer. Excitation can be either 5 or 10 volts
Output is available in several formats : 0/10 V, ± 10 V or 4/20 mA
Bridge can be hooked up in either 4 or 6 wire configuration
6 wire configuration will avoid any voltage loss between supply and the strain gauge due to long cable length
Module will also detect threshold limits, wire break of the sensor and supply loss
Failure signal is given through a relay
Two different thresholds can be easily set by potentiometers accessible from the front of the unit
Unit come in a PA PHOENIX polyamide housing, EM type, and can be clipped onto any DIN EN line (norm EN 50022)

Type		Strain gauge conditoner with threshold
Output		0-10 V, ± 10 V or 4 – 20 mA
Power supply		24 VDC
Bridge excitation		5 or 10 VDC
Bridge connection		4 or 6 wires
Temperature range		0°C ... +70°C
Protection		IP20
For mer informasjon		Klikk her --- Datablad